Siemens SINUMERIK 828D Programming Manual page 373

Significance
TRAANG( ) or
TRAANG( ,n)
TRAANG(α)
TRAANG(α,n)
αA
TRAFOOF
n
Angle α omitted or zero
If α (angle) is omitted (e.g.,
parameterization of the previous selection. On the first selection, the default settings
according to the machine data apply.
An angle α = 0 (e.g.,
equivalent to the omission of the parameter, as in the case of older versions.
Example
Job planning
Programming Manual, 07/2010, 6FC5398-2BP40-0BA0
Activate transformation with the parameterization of the previous
selection.
Activates the first specified inclined axis transformation
Activates the nth agreed inclined axis transformation. The maximum
value of n is 2. TRAANG(α,1) corresponds to TRAANG(α).
Angle of the inclined axis
Permissible values for α are:
-90 degrees < α < + 90 degrees
Transformation off
Number of agreed transformations
,
TRAANG() TRAANG(, n)
,
TRAANG(0) TRAANG(0,n)
6.8 Kinematic transformation
), the transformation is activated with the
) is a valid parameter setting and is no longer
Transformations
373