Siemens SINUMERIK 828D Programming Manual page 519

Significance
CTABNO
CTABNOMEM
CTABFNO
CTABSEGID
CTABSEG
CTABFSEG
CTABMSEG
CTABPOLID
CTABPOL
CTABFPOL
CTABMPOL
<n>
<memory location>
<segment type>
Job planning
Programming Manual, 07/2010, 6FC5398-2BP40-0BA0
Determine total number of defined curve tables (in the static and the
dynamic NC memory)
Determine the number of defined curve tables in the specified
<memory location>
Determine the number of curve tables remaining possible in the
specified
<memory location>
Determine the number of curve segments of the specified
used by curve table number
type>
Determine the number of curve segments of the specified
used in the specified
type>
Determine the number of curve segments of the specified
remaining possible in the specified
type>
Determine the maximum possible number of curve segments of the
specified
<segment type>
Determine the number of curve polynomials used by curve table
number
<n>
Determine the number of curve polynomials used in the specified
<memory location>
Determine the number of curve polynomials remaining possible in
the specified
<memory location>
Determine the maximum possible number of curve polynomials in
the specified
<memory location>
Number (ID) of curve table
Specification of memory location (optional)
"SRAM" Static NC memory
"DRAM" Dynamic NC memory
Note:
If a value is not programmed for this parameter, the default memory
location set with
MD20905 $MC_CTAB_DEFAULT_MEMORY_TYPE is used.
Specification of segment type (optional)
"L" Linear segments
"P" Polynomial segments
Note:
If no value is programmed for this parameter, the sum of the linear
and polynomial segments is output.
9.2 Curve tables (CTAB)
<n>
<memory location>
<memory location>
in the specified
<memory location>
Axis couplings
<segment
<segment
<segment
519