Siemens SINUMERIK 828D Programming Manual page 126

Hide thumbs Also See for SINUMERIK 828D:
Table of Contents

Advertisement

Flexible NC programming
1.15 Axis replacement, spindle replacement (RELEASE, GET, GETD)
GET request without preprocessing stop
If, following a GET request without preprocessing stop, the axis is enabled again with
RELEASE(axis)
An axis or spindle accepted with GET remains assigned to this channel even after a key or
program RESET.
When a program is restarted the replaced axes or spindles must be reassigned in the
program if the axis is required in its original channel.
It is assigned to the channel defined in the machine data on POWER ON.
Examples
Example 1: Axis exchange between two channels
Of the 6 axes, the following are used for machining in channel 1: 1st, 2nd, 3rd and 4th axis.
The 5th and 6th axes in channel 2 are used for the workpiece change.
Axis 2 should be exchanged between two channels and after POWER ON can be assigned
to channel 1.
Program "MAIN" in channel 1:
Program code
INIT (2,"TRANSFER2")
N... START (2)
N... GET (AX2)
...
N... RELEASE (AX2)
N... WAITM (1,1,2)
...
N... M30
Program "TRANSFER2" in channel 2:
Programming
N... RELEASE (AX2)
N160 WAITM(1,1,2)
N150 GET(AX2)
...
N... M30
126
or
WAITP(axis)
CAUTION
, a subsequent
will induce a
GET
Comments
; Select program TRANSFER2 in channel 2.
; Start the program in Channel 2.
; Accept axis AX2.
; Release axis AX2.
; Wait for WAIT marker in channel 1 and 2 for
synchronizing in both channels.
; Rest of program after axis replacement.
Comments
; Wait for WAIT marker in channel 1 and 2 for
synchronizing in both channels.
; Accept axis AX2.
; Rest of program after axis replacement.
Programming Manual, 07/2010, 6FC5398-2BP40-0BA0
with preprocessing stop.
GET
Job planning

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents