Siemens SINUMERIK 828D Programming Manual page 42

Flexible NC programming
1.1 Variables
Redefinition ( ) of NC language commands
REDEF
The access or execution right (
commands:
● G functions/Preparatory functions
● Predefined functions
● Predefined subprogram calls
●
● Cycles program identifier
Access rights in relation to part programs and cycles (
The various access rights facilitate the following with regard to access in a part program or
cycle:
●
●
42
References:
/PG/ Programming Manual, Fundamentals; Chapter: G functions/Preparatory functions
References:
/PG/ Programming Manual, Fundamentals; Chapter: Predefined functions
References:
/PG/ Programming Manual, Fundamentals; Chapter: Predefined subprogram calls
operation with synchronized actions
DO
The cycle must be saved in a cycle directory and must contain a PROC operation.
/
APRP 0 APWP 0
– During part program processing the system password has to be set.
– The cycle has to be stored in the _N_CST_DIR directory (system).
– The execution right must be set to system for the _N_CST_DIR directory in MD11160
$MN_ACCESS_EXEC_CST.
/ or
APRP 1 APWP 1 APRP 2
– During part program processing the machine manufacturer or service password has to
be set.
– The cycle has to be stored in the _N_CMA_DIR (machine manufacturer) or
_N_CST_DIR (system) directory.
– The execution rights must be set to at least machine manufacturer for the
_N_CMA_DIR or _N_CST_DIR directories in machine data MD11161
$MN_ACCESS_EXEC_CMA or MD11160 $MN_ACCESS_EXEC_CST respectively.
) can be redefined for the following NC language
APX
,
APRP APWP
/
APWP 2
Programming Manual, 07/2010, 6FC5398-2BP40-0BA0
)
Job planning