Siemens SINUMERIK 828D Programming Manual page 242

Special Motion Commands
4.2 Spline interpolation (ASPLINE, BSPLINE, CSPLINE, BAUTO, BNAT, BTAN, EAUTO, ENAT, ETAN, PW,
SD, PL)
Spline type
B spline
242
Properties and use
Features:
Does not run through the specified intermediate points along the curve, but
•
only close to them. The intermediate points to not attract the curve. The
curve characteristic can be additionally influenced by weighting the
intermediate points using a factor.
The curve characteristic is tangential with continuous curvature.
•
Does not generate any undesirable oscillations.
•
The area of influence of changes to intermediate points along the curve is
•
local. This means that a change to an intermediate point along the curve only
affects up to max. 6 adjacent intermediate points.
Application:
Their B spline is primarily intended as interface to CAD systems.
Programming Manual, 07/2010, 6FC5398-2BP40-0BA0
Job planning