Siemens SINUMERIK 828D Programming Manual page 365

Significance
TRACYL(d)
TRACYL (d, n)
D
n
Slot side compensation
TRAFOOF
OFFN
Note
An active
activated in the relevant channel (e.g.,
Example: Tool definition
The following example is suitable for testing the parameterization of the
transformation:
Program code
Tool parameters
Number (DP)
$TC_DP1[1,1]=120
$TC_DP2[1,1]=0
Program code
Geometry
$TC_DP3[1,1]=8.
$TC_DP4[1,1]=9.
$TC_DP5[1,1]=7.
Job planning
Programming Manual, 07/2010, 6FC5398-2BP40-0BA0
Activates the first TRACYL function specified in the channel
machine data. d is the parameter for the working diameter.
Activates the n-th TRACYL function specified in the channel
machine data. The maximum for n is 2, TRACYL(d,1)
corresponds to TRACYL(d).
Value for the working diameter. The working diameter is
double the distance between the tool tip and the turning
center. This diameter must always be specified and be larger
than 1.
Optional 2nd parameter for the TRACYL data block 1
(preselected) or 2.
Optional 3rd parameter whose value for TRACYL is
preselected using the mode for machine data.
Value range:
0: Transformation type 514 without groove wall offset as
previous
1: Transformation type 514 with groove wall offset
Transformation OFF (BCS and MCS are once again identical).
Offset contour normal: Distance of the groove side from the
programmed reference contour.
transformation is likewise deactivated if one of the other transformations is
TRACYL
Comments
Significance
Tool type
Tool nose position
Comments
Length compensation
Length offset vector
, ,
TRANSMIT TRAANG TRAORI
Comment
Milling tool
only for turning tools
Calculation acc. to type
and plane
Transformations
6.8 Kinematic transformation
).
cylinder
TRACYL
365