Ricoh A230 Service Manual page 635

Scanner Board Installation
4. Remove the shield plate [A] (4 screws).
5. Open the Scanner SCSI I/F window [B] in the plate.
6. Insert the Scanner Controller Board [C] in the third slot from the right of the
expansion box.
If the ISDN board has already been installed, perform steps 7 to 9.
7. Slide out the ISDN board [D].
8. Thread the ISDN modular cable [E] through the opening [F] in the scanner
board, as shown.
9. Install the Scanner Controller board and ISDN board in the expansion box at the
same time.
SM
[A]
[C]
[F]
21-7
INSTALLATION PROCEDURE
[D]
[E]
A230/A231/A232
[B]