Ricoh A230 Service Manual page 746

System Switch 04
No FUNCTION
5
Memory file transfer operation
0: Service level
1: User level
6
G3 CSI/G4 Terminal ID
programming level
0: User level
1: Service level
7 Telephone line type
programming mode
0: User level
1: Service level
System Switch 05
No FUNCTION
0
Not used
1
2
Display of both RTI and CSI
on the LCD
0: Disabled
1: Enabled
3 Not used
4 Hard disk option
0: Not installed
1: Installed
5
Not used
6
7
System Switch 06 - Not used (Do not change the factory settings.)
SM
COMMENTS
If the machine is unable to print fax messages
due to a mechanical problem, change this bit to 1
to transfer all messages in the memory (including
confidential rx messages) to an another terminal.
Always reset this bit to zero after transfer.
However, this bit can be left at 1, if the customer's
key-operator wants to transfer the files himself.
Procedure
1. Enter service mode and change this bit to 1.
2. Exit the service mode.
3. Enter the key-operator mode, and select 'Key-
operator settings'.
4. Choose '04' and specify a destination for the
machine to transfer all the files to.
5. Press 'OK'.
6. After the machine transfers the memory files,
enter the service mode and reset this bit to 0.
Otherwise, anybody who knows how to enter the
key-operator mode can transfer confidential
messages.
1: The CSI and Terminal ID can only be
programmed using a service function.
The Terminal ID can only be programmed if a
Group 4 option is installed.
1: Telephone line type selection (tone dial or
pulse dial) can only be programmed using a
service function.
COMMENTS
Do not change the settings.
1: An RTI will be displayed until phase B of the
protocol sequence, and a CSI will be displayed
after phase C.
Do not change the setting.
Change this bit to 1 when installing the hard disk
option.
Do not change the setting.
4-21
BIT SWITCHES
A230/A231/A232