Ricoh A230 Service Manual page 1105

BULLETIN NUMBER: BULLETIN NUMBER:
BULLETIN NUMBER: BULLETIN NUMBER:
APPLICABLE MODEL: : : : APPLICABLE MODEL
APPLICABLE MODEL APPLICABLE MODEL
GESTETNER – 3235S/3235/3245 GESTETNER – 3235S/3235/3245
GESTETNER – 3235S/3235/3245 GESTETNER – 3235S/3235/3245
RICOH – AFICIO 340/350/450/355/455 RICOH – AFICIO 340/350/450/355/455
RICOH – AFICIO 340/350/450/355/455 RICOH – AFICIO 340/350/450/355/455
SAVIN – 9935D/9935DP/9945DP/2035DP/2045DP SAVIN – 9935D/9935DP/9945DP/2035DP/2045DP
SAVIN – 9935D/9935DP/9945DP/2035DP/2045DP SAVIN – 9935D/9935DP/9945DP/2035DP/2045DP
SUBJECT: CONSTANT ADD TONER CONDITION
SYMPTOM:
1. Add toner condition will not clear after replacing the Toner Bottle.
2. When the Front Door is open, the display indicates "Close Right Cover."
CAUSE:
SP5-957 (Door Switch Type) is set incorrectly.
SOLUTION:
1. When the Right Door Switch kit is installed (Refer to TSB A230/A231/A232 – 032), SP5-957 must be set
to a 1. Follow the procedure outlined below:
•
Enter SP Mode.
•
Set SP5-957 to 1.
•
Exit SP Mode.
•
Turn the Main Power Switch OFF then ON.
•
Open the Front Door and confirm that the display reads "Close Doors/Covers."
2. If the Right Door Switch Kit is not installed, SP5-957 must be set to 0.
NOTE: When performing a Memory All Clear (SP5-801) or replacing NVRAM, confirm that SP5-957 is set
correctly. SP5-597 is available with firmware level "T" or higher.
   
2000 RICOH Corporation. All rights reserved.
TECHNICAL SERVICE BULLETIN TECHNICAL SERVICE BULLETIN
TECHNICAL SERVICE BULLETIN TECHNICAL SERVICE BULLETIN
A230/A231/A232 - 055 A230/A231/A232 - 055
A230/A231/A232 - A230/A231/A232 - 055 055
06/29/2000 06/29/2000
06/29/2000 06/29/2000
CONTROL NO. 042ABW