Software (Swapftl) Installation - Ricoh A230 Service Manual

3 SOFTWARE (SWAPFTL) INSTALLATION

CAUTION: 1) If you purchased SwapBox from an authorized SCM dealer, do not
use the software diskettes that are enclosed in the SwapBox
package.
2) Use the software diskette which is labeled "SwapBox Software/ RCH
SwapFTL + SwapUTI".
3) A software license is required to install a software package on a
computer.
4) The SwapFTL software may not work with some PC Card
(PCMCIA), CardBus, or ZV port controllers installed in notebook
computers.
3.1 SWAPFTL SOFTWARE INSTALLATION
1. Ensure that the SwapBox has been installed and configured under the
Windows 95 environment.
2. Insert the software diskette in the floppy disk drive.
3. Choose "Run" from the Start menu.
4. Type "A:\setup" and click OK.
5. Follow the instructions on the display.
6. Reboot the computer after installation has finished.
3.2 VERIFICATION
3.2.1 SOFTWARE VERSION
1. Choose "SwapFTL Binary Utility" from the "SCMSwapFTL" program group.
2. After the utility starts, choose [Help] – [About SwapUti..].
3. Confirm that the version information is as follows:
SM
SWAPBOX INSTALLATION
18-5
A203/A231/A232