Ricoh A230 Service Manual page 1056

Tech Service Bulletin No. A230/A231/A232 – 037 REISSUE " " " "
Page 3 of 4
5. Route the Harness under the Drive Belt as shown in the illustration, taking up any
slack.
6. Secure the other end of the Harness with the Screw [E] that secures the Stay.
[D]
[B]
7. Peel back the 2 strips of Mylar [A] attached to the Stay as shown in the illustration above.
8. Peel back the two-sided tape remaining on the Stay (approximately 4cm total,
centered around the Sensor [B]).
9. Remove the Screw [C] (securing the Stay) that is closest to the Sensor.
10. Place the new Plate Spring [D] (A6883914) over the Sensor, return the Mylar and
fasten with the Screw removed in step 9.
NOTE: Since there is a possibility of the roller slipping, clean the three Transport Rollers with alcohol or a
damp cloth.
[E]
[A]
[C]
Continued...