Ricoh A230 Service Manual page 196

[F]
8. Install the sensor bracket [A] (1 short stepped screw, 1 spring).
9. Connect the harnesses [B].
NOTE: 1) The harness binders [C] must not be between the harness clamps [D].
2) The harness binder [E] must be positioned to the left of the harness
clamp.
10. When a three-punch-hole unit is installed: Change switch 1 of DIP SW 100
on the finisher control board to ON.
11. Slide the hopper [F] into the finisher.
12. Reassemble the finisher and attach the 3,000-sheet finisher to the copier, then
check the punch unit function.
SM
[A]
[E]
A230I767.WMF
A231I511.WMF
A231I512.WMF
3-55
PUNCH UNIT INSTALLATION
[B]
[D]
A230/A231/A232
[C]