Installation Procedure - Ricoh A230 Service Manual

INTERCHANGE UNIT INSTALLATION

3.5.2 INSTALLATION PROCEDURE

[A]
[B]

CAUTION
Unplug the main machine power cord before starting the following
procedure.
1. Remove the scanner unit.
NOTE: If the ARDF is installed, remove the ARDF before removing the
scanner unit.
1) Remove the stand rear cover [A] (2 screws).
2) Disconnect the scanner I/F board [B] and the power connector [C].
3) Disconnect the scanner I/F harness [D].
4) Remove the scanner unit [E] (2 knob screws).
NOTE: 1) Hold the scanner unit as shown in the above illustration. Otherwise,
it will be damaged.
2) Make sure the harnesses are not damaged by the edges of the
opening [F].
3) After removing the scanner, keep it in a flat level place.
5) Remove four plates [G] (1 screw each).
6) Remove the scanner unit plate [H] (1 screw).
A230/A231/A232
[C]
[D]
A230I301.WMF
[G]
[F]
3-18
[E]
[G]
[H]
A230I302.WMF
SM