Rev. 09/2000
Description of Modification
Corrects the following:
•
In machines without the Image
Enhancement kit, the following
can occur after the paper end
condition is reached:
- The machine waits for the next
sheet of paper to be fed from the
tray.
- An SC321 occurs.
•
An SC990 occurs
1- No Hard Disk installed.
2- Firmware v 14.3 installed
3- Duplex Mode
4- Original on glass, press Start
5- Original in ADF, press Start
•
After making a copy from the
glass, no copies could be made
from the DF. "Original is left on
glass...Remove original" is
displayed when an original is set
in the DF.
•
Some parts of "Adjust Image"
screen are displayed in German
even though Dutch is set as the
language.
•
Some parts of "Adjust Image"
screen are displayed in English
even though Spanish is set as
the language.
⇒
Corrects the following:
•
When the main power switch is
turned on or the machine
recovers from Energy Saver
Mode, an SC990 (followed by
SC542) occurs before the target
fusing temperature is reached.
•
When the G909 Mailbox has
been selected as the output tray
when the machine recovers from
Energy Saver Mode, a jam
occurs at the G909 entrance.
This is because the G909 is not
recognized by the mainframe.
•
The thermistor output is unstable
when the main power is turned
on or the machine recovers from
Energy Saver Mode in a low-
temperature environment. This
causes an SC546 to occur.
•
An SC990 occurs when a print
job is cancelled at a certain point
during the job.
SM
Firmware Level
Serial Number
A2325113 V
December 1999
A2325113 W
Not Available
7-35
ROM HISTORY
Firmware
Version
14.4
production
14.5
A230/A231/A232