Swapbox Installation - Ricoh A230 Service Manual

SWAPBOX INSTALLATION

2 SWAPBOX INSTALLATION
2.1 HARDWARE INSTALLATION
CAUTION: 1) Before installing the SwapBox in a computer, turn off the computer
and disconnect the power cable.
2) This manual does not explain how to install an ISA board in your
computer. Refer to your computer's users manual for how to do it.
Install the SwapBox as explained in Chapter 1 to 3 of the SwapBox Manual that is
enclosed in the SwapBox package.
Then go on to the next section below for the driver installation.
2.2 DRIVER INSTALLATION
CAUTION: 1) Do not use the software disks that are enclosed with the SwapBox.
2) Ensure that you have Windows 95 - 4.00.950a or a later version
installed in your computer. (Refer to section 1.4 for more details.)
1. Turn on the computer. "SCM SwapBox" may appear during boot-up.
2. When Windows 95 starts, it finds the SwapBox automatically and installs the
necessary driver files from the Windows installation diskette(s) or CD-ROM.
3. After Windows starts, choose "PCCard" from the Control Panel.
• If PCCard Properties is displayed, driver installation has finished.
You can go on to the next section.
• If PCCard Wizard is displayed, go on to the next step.
4. In the PCCard Wizard, choose all the default settings to finish the wizard, then
reboot the computer.
5. After Windows 95 has restarted, choose "System" from the Control Panel.
6. Choose "Device Manager" and confirm that "SCM SwapBox Family Plug and
Play PCMCIA Controller" is listed in the PCMCIA socket category.
7. Double-click "SCM SwapBox Family Plug and Play PCMCIA Controller" and
confirm that the SwapBox is working properly.
SM
18-4
A203/A231/A232