Ricoh A230 Service Manual page 713

[N]
7. Set the locking support [M] and the edge saddle [N] as shown, then install the
NCU/Speaker assembly [O] (2 screws).
8. Connect the cable [P] and the harness [Q] as shown. The harness [Q] must run
through the edge saddle [N] as shown.
9. Turn on the battery switch (SW1) on the FCU [R] then insert the board into the
tracks for the right-most slot of the expansion box as shown. Connect the
harness [Q] to the FCU (CN328 and CN330), then slide the FCU [R] all the way
in (1 connector).
10. Install the bracket [S] (4 screws) and [T] (1 screw) as shown.
SM
[M]
[O]
[SW1]
A693I504.WMF
[S]
[Q]
[R]
A693I506.WMF
3-3
FAX UNIT
[P]
[Q]
[N]
A693I505.WMF
[T]
A693I512.WMF
A230/A231/A232