Ricoh A230 Service Manual page 1047

DEVELOPMENT
6.4 DEVELOPMENT
6.4.1 DEVELOPMENT UNIT
[A]
1. Open the right upper cover and front cover.
2. Remove the PCU. (See Photoconductor Unit.)
3. Remove the development unit [A] while pushing the release lever [B] to the
right.
⇒
NOTE 1: For machines produced after May 1999 follow Step 3A below.
3A. While loosening screw [C] , turn the bracket counterclockwise, then remove
the development unit [D].
NOTE 2: Be careful not to nick or scratch the development roller.
If you are temporarily installing a used development unit for test
purposes for a long time, perform SP2-220 and 2-802 after installation
(see the SP mode table for details).
A230/A231/A232
A230R401.WMF
Bracket
6-24
[B]
Step 3A [C]
Rev. 11/04/99
[D]
SM