Ricoh A230 Service Manual page 784

G3 Switch 0A
No FUNCTION
0
Maximum allowable carrier
1
drop during image data
reception
Bit 1 Bit 0
0 0
0 1
1 0
1 1
2
Not used
3
4 Maximum allowable frame
interval during image data
reception.
0: 5 s 1: 13 s
5
Not used
6
Reconstruction time for the
first line in receive mode
0: 6 s 1: 12 s
7
Not used
SM
These bits set the acceptable modem carrier drop
time.
Try using a longer setting if error code 0-22 is
Value (ms) frequent.
200
400
800
Not used
Do not change the settings.
This bit set the maximum intervals between each
EOL signal (end-of-line) or intervals between
each ECM frame from the other end.
Try using a longer setting if error code 0-21 is
frequent.
Do not change the setting.
When the sending terminal is controlled by a
computer, there may be a delay in receiving page
data after the local machine accepts set-up data
and sends CFR. This is outside the T.30
recommendation. But, if this delay occurs, set this
bit to 1 to give the sending machine more time to
send data.
Refer to error code 0-20.
ITU-T T.30 recommendation: The first line should
come within 5 s of CFR.
Do not change the setting.
4-59
BIT SWITCHES
COMMENTS
A230/A231/A232