Ricoh A230 Service Manual page 877

Parameter Switch 08
No. FUNCTION
4 Not used
to
7
Parameter Switch 09
No. FUNCTION
0 LCGN
1 Bit 3 2 1 0 Value
2 0 0 0 0 0
3 0 0 0 1 1
0 0 1 0 2
and so on until
1 1 1 1 15
4 Not used
to
7
Parameter Switch 0A
No.
0 LCN
1 Bit 7 6 5 4 3 2 1 0 Value
2 0 0 0 0 0 0 0 1 1
3
0 0 0 0 0 0 1 0 2
4 0 0 0 0 0 0 1 1 3
5 and so on until
6
1 1 1 1 1 1 1 1 255
7
Parameter Switch 0B
No. FUNCTION
0 Transport block size
1 Bit 3 2 1 0 Value
2 0 1 1 1 128
3
1 0 0 0 256
1 0 0 1 512
1 0 1 0 1024
1 0 1 1 2048
4 Not used
to
7
Parameter Switch 0C is not used. Do not change any of the default settings.
SM
Do not change the default settings.
Keep the value of the LCGN at 0.
Do not change the default settings.
FUNCTION
This value must match the value set in the other
terminal. Note that this value must be the same
as the value programmed for the packet size (G4
Parameter Switch 7, bits 0 to 3). Also, the
transport block size is limited by the amount of
memory in the remote terminal.
Do not change the default settings.
2-13
COMMENTS
COMMENTS
COMMENTS
Keep at the value of the LCN at 1.
COMMENTS
A230/A231/A232
BIT SWITCHES