3.3 LEDS
There are six LEDs on the G4 Interface board, as shown below.
These LEDs give the following information about the status of the machine.
Initial Settings
Power-up/Reset
Initial setting request from FCU
Initial setting confirmation to FCU
Communication
Layer 1 activated
Layer 2 set
B channel connected (ISDN G4)
B channel connected (ISDN G3)
B channel released
Layer 2 released
Layer 1 deactivated
The following will be displayed if bit 1 of G4 parameter switch E is at 1.
B channel: send I frame (A blinks at this time if bit 1 of
G4 parameter switch E is at 1)
B channel: receive I frame (B blinks at this time if bit 1 of
G4 parameter switch E is at 1)
Note: At the start and end of communication, both A and B will blink.
SM
LED 1
LED 2
3-9
LED 5
LED 6
LED 3
LED 4
O=ON, --=OFF
--
--
--
O
O
O
O
O
O
--
O
O
LEDS
O
O
--
--
--
--
O
--
--
--
--
--
--
--
--
--
--
--
--
--
--
--
O
--
--
--
--
O
O
--
--
--
O
--
O
--
--
O
--
--
--
--
--
--
--
--
--
--
--
--
--
A
O
O
--
B
--
O
O
--
A230/A231/A232