Ricoh A230 Service Manual page 1104

Rev. 05/2000
6.4 FIRMWARE HISTORY
6.4.1 A693 FIRMWARE MODIFICATION HISTORY
A693 FAX OPTION FIRMWARE MODIFICATION HISTORY
DESCRIPTION OF MODIFICATION
•
Cannot print out incoming fax.
Even if only one of the output trays has not
been set properly, it is not possible to print
out an incoming fax to any tray.
•
System Switch
The default for System Switch 0A (Germany)
has been changed from 00H to 30H.
•
Print end buzzer
If fax printout and communication finish at
the same time when using Direct Receive,
the print end buzzer does not turn off.
•
SC101 does not stop transmission
Transmission is not stopped even if SC101
occurs.
•
Duplex Print
Page order is reversed in duplex mode if the
page memory unit has not been installed
(2/1, 4/3). The specifications have been
changed so that the order will be 1/2, 3/4
(correct).
As part of this modification, the default for
Printer SW 0F bit 5 has been changed to 1.
•
FCC Standards (86)
The following modification was made to
comply with the changes made to FCC
standards (86) and applies only to
A2335581 G :
The default for communication SW10 has
been changed to 02H.
The default for communication SW12 has
been changed to OAH.
SM
FIRMWARE SERIAL
LEVEL NUMBER
A2335581 G
6-21
FIRMWARE HISTORY
FIRMWARE
VERSION
NA 10.00
11.00
12.00
A230/A231/A232