Ricoh A230 Service Manual page 717

3.3 HARD DISK
NOTE: To install this option, a fax unit, an expansion box, and an EXSAF are also
required.
[B]
[K]
[G]
[H]
1. Remove the rear cover (4 screws) and the left-side cover (4 screws).
2. Disconnect the harness [A], remove the expansion box [B] (1 harness), remove
the FCU cover bracket [K]. Then remove the FCU from the box.
3. Make sure that the EXSAF board [C] has been installed on the FCU [D] and the
battery switches on both FCU and EXSAF are turned on. Then, connect the
harness [E] to the EXSAF board [C].
4. Attach the brackets [F] and the grounding plate [G] to the hard disk drive [H] as
shown. (4 screws)
5. Install the hard disk assembly [I] in the expansion box [J] (4 screws) .
SM
[A]
A818I502.WMF
[F]
[F]
A818I504.WMF
3-7
[C]
[D]
[I]
A230/A231/A232
HARD DISK
[E]
A818I503.WMF
[J]
A818I505.WMF