Yamaha RCX40 User Manual page 242

12. "SYSTEM" mode
4
n
NOTE
Data omissions may occur if data
flow control is not performed. Make
use of data flow control as much as
possible.
182
4-
6. Termination code
This parameter sets the line feed code.
[Procedure]
1) Select "6. Termination code" in "SYSTEM>CMU" mode.
2) Press the (EDIT) key.
F 1
The function key menu changes.
Fig. 4-12-54 Setting the "Termination code"
SYSTEM>CMU
3.Baud rate
4.Stop bit
5.Parity
6.Termination code
7.XON/XOFF control
CR CRLF
3) Select the line feed with the
4) Press the key to quit the setting. To continue selecting other items, use the
ESC
cursor (↑/↓) keys.
7. XON/XOFF control
This parameter sets whether to control the data flow using XON/XOFF control.
[Procedure]
1) Select "7. XON/XOFF control" in "SYSTEM>CMU" mode.
2) Press the (EDIT) key.
F 1
The function key menu changes.
Fig. 4-12-55 Setting the "XON/XOFF control"
SYSTEM>CMU
3.Baud rate
4.Stop bit
5.Parity
6.Termination code
7.XON/XOFF control
YES NO
3) Select XON/XOFF control with the
4) Press the key to quit the setting. To continue selecting other items, use the
ESC
cursor (↑/↓) keys.
V8.01
9600
1
ODD
CR
YES
(CR) or (CRLF) key.
F 1 F 2
V8.01
9600
1
ODD
CR
YES
(YES) or
F 1 F 2
(NO) key.