Digisol DG-GS4826S Management Manual page 1189

C
Privileged Exec
C
Using this command with the "all" parameter clears the RIP table of all
routes. To avoid deleting the entire RIP network, use the
connected
the RIP routes learned from neighbors and also keep the RIP network
intact, use the "rip" parameter with this command (clear ip rip route rip).
E
This example clears one specific route.
show ip protocols
This command displays RIP process parameters.
rip
C
Privileged Exec
E
M
OMMAND ODE
U
OMMAND SAGE
command to make the RIP network a connected route. To delete
XAMPLE
Console#clear ip rip route 192.168.1.0 255.255.255.0
Console#
M
OMMAND ODE
XAMPLE
Console#show ip protocols rip
Routing Protocol is "rip"
Sending updates every 30 seconds with +/-5 seconds
Timeout after 180 seconds, garbage collect after 120 seconds
Outgoing update filter list for all interface is not set
Incoming update filter list for all interface is not set
Default redistribution metric is 1
Redistributing:
Default version control: send version by interface set,receive version by
interface set
Interface Send
VLAN1 1-compatible 1 2
Routing for Networks:
10.0.0.0/24
Routing Information Sources:
Gateway Distance
10.0.0.2
The maximum number of RIP routes allowed: 7872
Distance: Default is 120
Console#
– 1189 –
C
HAPTER
Routing Information Protocol (RIP)
Recv
Last Update Bad Packets
120 00:00:13 0
48 | IP Routing Commands
redistribute
Bad Routes
0