Digisol DG-GS4826S Management Manual page 1171

gateway-address – IP address of the next hop router used for this
route.
link-local-address%zone-id – a link-local address, including a
zone-id indicating the VLAN identifier after the % delimiter.
distance – An administrative distance indicating that this route can
be overridden by dynamic routing information if the distance of the
dynamic route is less than that configured for the static route. Note
that the default administrative distances used by the dynamic
unicast routing protocols is 110 for OSPF and 120 for RIP.
(Range: 1-255, Default: 1)
interface-number – The number of the outgoing tunnel interface
used to reach the destination IPv6 address. (Range: 1-16)
See the interface tunnel
D S
EFAULT ETTING
No static routes are configured.
C M
OMMAND ODE
Global Configuration
C U
OMMAND SAGE
Up to 1K static routes can be configured.
u
Up to eight equal-cost multipaths (ECMP) can be configured for static
u
routing using the maximum-paths
If an administrative distance is defined for a static route, and the same
u
destination can be reached through a dynamic route at a lower
administration distance, then the dynamic route will be used.
The default distance of 1 will take precedence over any other type of
u
route, except for local routes.
If both static and dynamic paths have the same lowest cost, the first
u
route stored in the routing table, either statically configured or
dynamically learned via a routing protocol, will be used.
Static routes are included in RIP and OSPF updates periodically sent by
u
the router if this feature is enabled by the OSPFv3
command (see page
E
XAMPLE
This example forwards all traffic for subnet 2001::/64 to the next hop
router 2001:DB8:2222:7272::254, using the default metric of 1.
Console(config)#ipv6 route 2001::/64 2001:DB8:2222:7272::254
Console(config)#
R C
ELATED OMMANDS
show ip route summary (1167)
– 1171 –
C
HAPTER
command for more information.
command.
1241).
48 | IP Routing Commands
Global Routing Configuration
redistribute