W
EB
To display LACP settings and status for the remote side:
1.
2.
3.
4.
5.
Figure 58: Displaying LACP Port Remote Information
Use the Interface > Trunk > Load Balance page to set the load-distribution
C
ONFIGURING
method used among ports in aggregated links.
L
B
OAD
ALANCING
CLI R
◆
C
OMMAND
◆
◆
I
NTERFACE
Click Interface, Trunk, Dynamic.
Select Configure Aggregation Port from the Step list.
Select Show Information from the Action list.
Click Internal.
Select a group member from the Port list.
EFERENCES
"port channel load-balance" on page 1022
U
SAGE
This command applies to all static and dynamic trunks on the switch.
To ensure that the switch traffic load is distributed evenly across all
links in a trunk, select the source and destination addresses used in the
load-balance calculation to provide the best result for trunk
connections:
Destination IP Address: All traffic with the same destination IP
■
address is output on the same link in a trunk. This mode works best
– 189 –
| Interface Configuration
C
5
HAPTER
Trunk Configuration