To configure connection parameters for a dynamic trunk:
1.
2.
3.
4.
5.
Figure 54: Configuring Connection Settings for a Dynamic Trunk
To show connection parameters for a dynamic trunk:
1.
2.
3.
Figure 55: Showing Connection Parameters for Dynamic Trunks
Use the Interface > Trunk > Dynamic (Configure Aggregation Port - Show
D
LACP
ISPLAYING
Information - Counters) page to display statistics for LACP protocol
P
C
ORT
OUNTERS
messages.
CLI R
◆
Click Interface, Trunk, Dynamic.
Select Configure Trunk from the Step list.
Select Configure from the Action list.
Modify the required interface settings. (See
on page 156
for a description of the interface settings.)
Click Apply.
Click Interface, Trunk, Dynamic.
Select Configure Trunk from the Step list.
Select Show from the Action list.
EFERENCES
"show lacp" on page 1030
– 185 –
| Interface Configuration
C
5
HAPTER
Trunk Configuration
"Configuring by Port List"