ip igmp filter
(Interface Configuration)
Table 122: IGMP Authentication RADIUS Attribute Value Pairs
Attribute Name
NAS_PORT
FRAMED_IP_ADDRESS
Example
This example shows how to enable IGMP Authentication on all of the switch's
Ethernet interfaces.
Console(config)#interface ethernet 1/1-28
Console(config-if)#ip igmp authentication
Console#
Related Commands
show ip igmp authentication
This command assigns an IGMP filtering profile to an interface on the switch. Use
the no form to remove a profile from an interface.
Syntax
[no] ip igmp filter profile-number
profile-number - An IGMP filter profile number. (Range: 1-4294967295)
Default Setting
None
Command Mode
Interface Configuration
Command Usage
◆
The IGMP filtering profile must first be created with the
command before being able to assign it to an interface.
◆
Only one profile can be assigned to an interface.
◆
A profile can also be assigned to a trunk interface. When ports are configured as
trunk members, the trunk uses the filtering profile assigned to the first port
member in the trunk.
Example
Console(config)#interface ethernet 1/1
Console(config-if)#ip igmp filter 19
Console(config-if)#
Chapter 22
AVP Type
5
8
– 611 –
| Multicast Filtering Commands
IGMP Filtering and Throttling
(Continued)
Entry
User Port Number
Multicast Group ID
ip igmp profile