Enabling Igmp Filtering And Throttling; Configuring Igmp Filter Profiles - Edge-Core ECS4810-12M Layer 2 Management Manual

dropped. If the action is set to replace, the switch randomly removes an
existing group and replaces it with the new multicast group.
Use the Multicast > IGMP Snooping > Filter (Configure General) page to
E IGMP
NABLING
enable IGMP filtering and throttling globally on the switch.
F
ILTERING AND
T
HROTTLING
CLI R
◆
P
These parameters are displayed:
◆
W
To enable IGMP filtering and throttling on the switch:
1.
2.
3.
4.
Figure 332: Enabling IGMP Filtering and Throttling
Use the Multicast > IGMP Snooping > Filter (Configure Profile – Add) page
C IGMP
ONFIGURING
to create an IGMP profile and set its access mode. Then use the (Add
F P
ILTER ROFILES
Multicast Group Range) page to configure the multicast groups to filter.
CLI R
◆
C
Specify a range of multicast groups by entering a start and end IP address;
or specify a single multicast group by entering the same IP address for the
start and end of the range.
EFERENCES
"ip igmp filter (Global Configuration)" on page 1030
ARAMETERS
IGMP Filter Status – Enables IGMP filtering and throttling globally for
the switch. (Default: Disabled)
I
EB NTERFACE
Click Multicast, IGMP Snooping, Filter.
Select Configure General from the Step list.
Enable IGMP Filter Status.
Click Apply.
EFERENCES
"IGMP Filtering and Throttling" on page 1030
U
OMMAND SAGE
– 551 –
| Multicast Filtering
C 18
HAPTER
Filtering and Throttling IGMP Groups