Displaying Connection Status - Edge-Core ECS4110-28T Management Manual

D
ISPLAYING
C S
ONNECTION TATUS
Figure 30: Configuring Connections by Port Range
Use the Interface > Port > General (Show Information) page to display the
current connection status, including link state, speed/duplex mode, flow
control, and auto-negotiation.
CLI R
EFERENCES
"show interfaces status" on page 1007
◆
P
ARAMETERS
These parameters are displayed:
Port – Port identifier.
◆
Type – Indicates the port type. (100BASE-FX, 1000BASE-T,
◆
1000BASE SFP)
Name – Interface label.
◆
Admin – Shows if the port is enabled or disabled.
◆
Oper Status – Indicates if the link is Up or Down.
◆
◆ Media Type – Media type used.
Autonegotiation – Shows if auto-negotiation is enabled or disabled.
◆
Oper Speed Duplex – Shows the current speed and duplex mode.
◆
Oper Flow Control – Shows the flow control type used.
◆
W I
EB NTERFACE
To display port connection parameters:
Click Interface, Port, General.
1.
Select Show Information from the Action List.
2.
– 159 –
| Interface Configuration
C 5
HAPTER
Port Configuration