Edge-Core ECS4110-28T Management Manual page 223

When a frame enters a port that has been assigned to a protocol VLAN,
◆
it is processed in the following manner:
If the frame is tagged, it will be processed according to the standard
■
rules applied to tagged frames.
If the frame is untagged and the protocol type matches, the frame
■
is forwarded to the appropriate VLAN.
If the frame is untagged but the protocol type does not match, the
■
frame is forwarded to the default VLAN for this interface.
P
ARAMETERS
These parameters are displayed:
Interface – Displays a list of ports or trunks.
◆
Port – Port Identifier. (Range: 1-28/52)
◆
Trunk – Trunk Identifier. (Range: 1-16)
◆
Protocol Group ID – Protocol Group ID assigned to the Protocol VLAN
◆
Group. (Range: 1-2147483647)
◆ VLAN ID – VLAN to which matching protocol traffic is forwarded.
(Range: 1-4094)
Priority – The priority assigned to untagged ingress traffic.
◆
(Range: 0-7, where 7 is the highest priority; Default: 0)
W I
EB NTERFACE
To map a protocol group to a VLAN for a port or trunk:
Click VLAN, Protocol.
1.
Select Configure Interface from the Step list.
2.
Select Add from the Action list.
3.
Select a port or trunk.
4.
Enter the identifier for a protocol group.
5.
Enter the corresponding VLAN to which the protocol traffic will be
6.
forwarded.
Set the priority to assign to untagged ingress frames.
7.
Click Apply.
8.
– 223 –
| VLAN Configuration
C 6
HAPTER
Protocol VLANs