Advertisement
S7810M MODBUS™ MODULE
1-1/8 (29)
BURNER CONTROL
4-27/32 (123)
M11349A
Fig. 1. Mounting dimensions of
S7810M ModBus™Module in in. (mm).
INSTALLATION
When Installing this Product...
1.
Read these instructions carefully. Failure to follow them could
damage the product or cause a hazardous condition.
2.
Check the ratings given in the instructions and marked on the
product to make sure the product is suitable for your
application.
3.
The installer must be a trained, experienced flame safeguard
technician.
4.
Disconnect the power supply before beginning installation to
prevent electrical shock and equipment damage. More than
one power supply disconnect can be required.
5.
Wiring must comply with all applicable codes, ordinances and
regulations.
6.
After installation is complete, check out product operation as
provided in these instructions.
IMPORTANT:
This equipment can cause interference with radio com-
munications.
This equipment generates, uses, and can radiate radio
frequency energy, and if not installed and used in
accordance with the Instructions Manual, may cause
interference with radio communications. It has been tested
and found to comply with the limits for a Class B computing
device pursuant to Subpart J of Part 15 of FCC Rules,
which are designed to provide reasonable protection
against such interference when operated in a commercial
environment. Operation of this equipment in a residential
area is likely to cause interference, in which case, users, at
their own expense, will be required to take whatever
measures may be required to correct the interference. Any
unauthorized modification of this equipment may result in
the revocation of the owner's authority to continue its
operation. When operating the S7810M remotely with a
separate power supply, FCC compliance is not guaranteed
unless an FCC-approved power supply is used.
ORDERING INFORMATION
When purchasing replacement and modernization products from your TRADELINE® wholesaler or distributor, refer to the
TRADELINE® Catalog or price sheets for complete ordering number.
If you have additional questions, need further information, or would like to comment on our products or services, please write or
phone:
1. Your local Home and Building Control Sales Office (check white pages of your phone directory).
2. Home and Building Control Customer Relations
Honeywell, 1885 Douglas Drive North
Minneapolis, Minnesota 55422-4386
In Canada—Honeywell Limited/Honeywell Limitée, 35 Dynamic Drive, Scarborough, Ontario M1V 4Z9.
International Sales and Service Offices in all principal cities of the world. Manufacturing in Australia, Canada, Finland, France,
Germany, Japan, Mexico, Netherlands, Spain, Taiwan, United Kingdom, U.S.A.
65-0249—4
7/16 (11)
MODE
2-3/4
(69)
5/32
(4)
29/32 (23)
2
Canadian EMI: This digital apparatus does not exceed the Class B
limits for radio noise emission from digital apparatus set out in the
Radio Interference Regulations of the Canadian Department of
Communications.
Le présent appareil numérique n'émet pas de bruits radioélectriques
depassant les limites applicables aux appareils numériques de la
Classe B prescrites dans le Règlement sur le brouillage
radioélectrique édicté par le ministère des Communications du
Canada.
Humidity
Install the S7810M where the relative humidity never reaches the
saturation point. The S7810M is designed to operate in a maximum
humidity environment of 85 percent relative humidity, continuous,
noncondensing moisture.
Weather
The S7810M is not designed to be weather-tight. When installed
outdoors, protect the S7810M with an approved weather-tight
enclosure.
Vibration
Do not install the S7810M where it could be subjected to vibration in
excess of 0.5G continuous maximum vibration.
Mounting the S7810M ModBus™ Module (Fig. 2).
1.
Align the two ears of the ModBus™ Data ControlBus™ Module
with the two mating slots on the 7800 SERIES Relay Module.
2.
Insert the two interlocking ears into the two mating slots
and, with a hinge action, push on the lower corners of the
ModBus™ Data ControlBus™ Module to secure it to the
7800 SERIES Relay Module.
Fig. 2. ModBus™ Module mounting.
Advertisement
