System Start-Up And Operation; Ignition - Honeywell Notifier NFG-8 Installation And Operation Manual

3)

SYSTEM START-UP AND OPERATION

This chapter describes the procedures for operating the NFG-8 control unit.
The NFG-8 control unit can be programmed only by means of a Personal Computer with
the appropriate software.
3.1)

Ignition

After checking that the system has been installed correctly, the NFG-8 control unit can
be switched on.
At the first power on, after a Warm Up time (3 minutes by default), the display will not
show any indication because at the first power on the control unit requires to be
programmed.
PAGE - 10
NOTIFIER ITALY
Fig. 3-10) Central front panel
Fig. 3-1) Warm Up Window
Installation and Operation
Manual Doc. M-040.1-NFG8-EN
Rev A.3
NFG-8
NFG-8_manu-inst_ITA