Connecting The Line Network To The External Patch Panel; Figure 4-42 Layout Of The Patch Panel S30807-K6143-X For Different - Siemens HiPath 5000 Service Manual

inst_h3.fm
Installing HiPath 3000
Installing HiPath 3800
4.2.7.2.2

Connecting the Line Network to the External Patch Panel

Danger
7
Be sure to connect the main protective earthing terminal on all system cabinets and
all patch panels to the grounding point of the electrical building installation before
connecting up the peripherals (for example, potential equalization bus).
Telephones and trunks are connected directly to the MW8 jack on the front of the patch panel.
Information on MW8 jack assignment on the front of the patch panel is provided in the board
descriptions (in the "Cable and Connector Assignment" table) in Chapter 3.
Surge protector
To divert surges caused by lightning, insert surge protectors on
lines that leave the system buildings (outside stations)
●
lines > 500 m long.
●
Connect the polarized surge protectors to the plugging locations F1 to F8 provided on the patch
panel (see Figure 4-43).
1
Example 1
2
1
Example 2
2
1
Example 3
2
Figure 4-42 Layout of the Patch Panel S30807-K6143-X for Different Peripheral Boards
4-74
Front panel with 3 x 16 MW8 jacks each
3 5 7 9 11 13 15
4 6 8 10 12 14 16
Board with 16 ports
3 5 7 9 11 13 15
4 6 8 10 12 14 16
Board with 24 ports
3 5 7 9 11 13 15
4 6 8 10 12 14 16
Board with 16 ports
HiPath 3000 V6.0, HiPath 5000 V6.0, Provisional Service Manual
17 19 21 23 25 27 29 31
18 20 22 24 26 28 30 32
Board with 16 ports
17 19 21 23 25 27 29 31
18 20 22 24 26 28 30 32
Board with 16 ports
17 19 21 23 25 27 29 31
18 20 22 24 26 28 30 32
Board with 24 ports
33 35 37 39 41 43
34 36 38 40 42 44
33 35 37 39 41 43
34 36 38 40 42 44
33 35 37 39 41 43
34 36 38 40 42 44
P31003-H3560-S403-54-7620, 09/05
45 47
46 48
45 47
46 48
45 47
46 48