Figure 4-11 Hipath 3800 - Removing Cabinet Feet - Siemens HiPath 5000 Service Manual

Hide thumbs Also See for HiPath 5000:

Table of Contents

Installing HiPath 3000

Installing HiPath 3800

Never attempt to lift a system cabinet into the 19-inch cabinet without assistance.

Remove all four cabinet feet from the system cabinet.

To do this, unscrew the lock nuts (Figure 4-11, A) on the cabinet feet using an

open-end wrench (wrench size = 13 mm). Unscrew cabinet feet completely.

Attach the two angle brackets (A in Figure 4-12) to the sides of the system cabinet

using the screws that have been supplied (four per bracket).

Attach a right-handed and a left-handed support bracket (B in Figure 4-12) in the

19-inch cabinet using the screws provided.

Note: the use of cabinet floors is not permitted to prevent overheating.

Lift the system cabinet into the 19-inch cabinet and sit the cabinet on the two sup-

port brackets (B in Figure 4-12). Slide the cabinet into the 19-inch cabinet until the

front edge of the system cabinet is flush with the front of the 19-inch frame.

Secure the system cabinet using the two angle brackets (A, in Figure 4-12) on the

frame of the 19-inch cabinet using the screws provided.

Please note that a minimum clearance of three height units must be observed be-

tween two stacked system cabinets. A minimum clearance of one free height unit

above a system cabinet is sufficient if a patch panel is to be installed, for example.

Repeat steps 1 to 5 if you want to install an expansion cabinet.

HiPath 3800 - Removing Cabinet Feet

HiPath 3000 V6.0, HiPath 5000 V6.0, Provisional Service Manual

P31003-H3560-S403-54-7620, 09/05

Chapters

Table of Contents

Hipath 3000 Hipath 3800