Recording Hipath 3000 Trunk Status - Siemens HiPath 5000 Service Manual

service.fm
Service
Guided Maintenance
Locking out and releasing boards and ports
Using the HiPath 3000 Manager E and Assistant T, you can lock out a complete station or trunk
module. The lockout prevents renewed seizure after the current connection has finished. Re-
lease or lockout settings are also retained after a reset.
The first SLMO/SLU board can be blocked. This action does not block the first two ports. You
can block specific ports with the "Block selection" option.
Ports of an IVM or HG 1500 board cannot be locked.
When attempting to lock out the last active trunk, you are subsequently notified that remote ser-
vice through the service center is no longer possible.
12.3.1.2

Recording HiPath 3000 Trunk Status

HiPath 3000 records the current status of each individual trunk in a table. If the status changes,
the new status along with the time stamp is entered. You can use HiPath 3000 Manager E to
view the trunk status, in which case the following information is provided.
Data
Date
Time
Trunk number
Slot/Port
Status
12-26
Date of the event (as stored in system)
Time of the event (as stored in system)
Number of the trunk
Slot and port number
Trunk status:
●
– Inactive
– Incoming call
– Outgoing call
– Trunk-to-trunk connection
– Trunk disabled (using lockout switch or HiPath 3000 Man-
ager E)
– Trunk failure
Number of the connected station
●
HiPath 3000 V6.0, HiPath 5000 V6.0, Provisional Service Manual
Contents
P31003-H3560-S403-54-7620, 09/05