Siemens HiPath 5000 Service Manual page 481

4.2 Installing HiPath 3800
4.2.1 Installation Prerequisites
Warning
7
Only authorized service personnel should install and start up the system.
Tools and resources needed
The following are needed for installing the HiPath 3800 system:
Tools:
●
– Hex or open-end wrench, 8 mm, open-end wrench 13 mm
– Diagonal cutting pliers, telephone pliers, wire stripper, flat-nosed pliers
– Slotted screwdrivers, from 2 to 8 mm (1/4 to 5/16 in.)
– Phillips or cross-point screwdrivers, sizes 1 and 2
– TORX screwdriver
– Wire stripper (for example, from Krone)
– Board wrench (part no. C39300-A7194-B10)
– Electric drill, hammer
– Level, tape measure
– For U.S. only: Punch-down tool suitable for the block used (such as block 66)
Resources:
●
– Assistant T or HiPath 3000 Manager E
– Digital multimeter for testing ground connections and partial voltages
– Telephone test set for analog interfaces
– Not for U.S.: ISDN tester (such as K3000 or Aurora)
– For U.S. only: Aurora
P31003-H3560-S403-54-7620, 09/05
HiPath 3000 V6.0, HiPath 5000 V6.0, Provisional Service Manual
Duet Expert,
, Aurora Aurora
Installing HiPath 3000
Installing HiPath 3800
Remote
or similar, ISDN protocol analyzer
inst_h3.fm
4-3