Figure 3-167 Reals Slots In The Basic Cabinet (With Outer Panel Mounted) - Siemens HiPath 5000 Service Manual

Hide thumbs Also See for HiPath 5000:

Table of Contents

Insert the REALS board into the slot marked 3 in the lower part of the shelf in the basic cabinet

and apply pressure until you hear a click (see Figure 4-22).

The slots for the power supply units and for the REALS board must be covered with an outer

panel before the system is started up. The outer panel is fixed onto the shelf with screws (see

Figure 3-167).

Figure 3-167

REALS Slots in the Basic Cabinet (With Outer Panel Mounted)

Cable and connector assignment

Table 3-174 shows the assignment of the SIVAPAC connector X116 on the backplane and the

assignment of the jumper strip in the MDFU-E.

P31003-H3560-S403-54-7620, 09/05

HiPath 3000 V6.0, HiPath 5000 V6.0, Provisional Service Manual

Boards for HiPath 3000

Chapters

Table of Contents

Hipath 3000 Hipath 3800