Siemens HiPath 5000 Service Manual page 813

Step
1. Upgrade HiPath 3000 to
2. At this point no steps are required. On startup, the optiClient Attendant identifies the
HiPath 3000 software version and waits for a boot signal from HiPath 3000
The IP address and port number of the CLA (configuration parameters) are not re-
quired when connecting a HiPath 3000
3. Read the customer data record of the HiPath 3000
4. Read out the MAC address of the HiPath 3000 control board.
5. Perform a rehost on the CLS (change license to a new MAC address).
This procedure can only be performed directly via the CLS (direct communication
with the CLS via web browser).
6. Transfer the license key or save it to the buffer memory.
This is completed by manually entering the license to the CLA (performed on the
CLM, offline activation).
7. Write the customer data record to HiPath 3000
8. Install optiClient Attendant(s).
"Any" number of optiClient Attendants can be installed. However, HiPath 3000 moni-
tors the number of licensed optiClient Attendants as part of the logon procedure.
Depending on the model, up to six optiClient Attendants can be started per system.
When the HiPath 3000 is started for the first time, a 30-day grace period begins. Dur-
ing this time, all HiPath 3000 features that require licensing (including optiClient At-
tendant) can be operated without a license. All features that require a license (includ-
ing HiPath 3000s that have been subsequently installed) must be licensed before the
grace period of the optiClient Attendant expires. The 30-day limit cannot be extended
and a second grace period will not be granted.
In this case, the CLS generates a license key for HiPath 3000
P31003-H3560-S403-54-7620, 09/05
HiPath 3000 V6.0, HiPath 5000 V6.0, Provisional Service Manual
Activity (Remarks)
V5.0.
V5.0.
Licensing optiClient Attendant
V5.0.
V5.0.
V5.0.
licensing.fm
Licensing
V5.0.
8-35