Figure 4-51 Hipath 3750 Mounting A One-Cabinet System On The Wall - Siemens HiPath 5000 Service Manual

inst_h3.fm
Installing HiPath 3000
Installing HiPath 3750, HiPath 3700
Step
2. Use the wall-mounting bracket as a template to drill three holes in the backboard.
Use the keyed holes in the top of the bracket and the round hole in the bottom of the
bracket.
3. Install the screws in the top two holes, tightening them until 0.25 in. (6.35 mm) is pro-
truding.
4. Bolt the swing-out assembly on the wall-mounting bracket to the back of the cabinet.
5. Close the swing-out assembly; Then mount the bracket and cabinet on the top
screws.
6. Swing the cabinet open and tighten the top screws completely.
7. Insert and fully tighten the bottom screw in the round hole.
8. Bolt the latching assembly to the opposite edge of the cabinet.
You can invert the bracket to have the cabinet swing out in the opposite direction.
WARNING
7
Do not fasten power cords to building surfaces when mounting cabinets on the wall.
Wall Mounting (One-Cabinet System)
Figure 4-51 HiPath 3750 Mounting a One-Cabinet System on the Wall (for U.S. only)
4-96
Activity
HiPath 3000 V6.0, HiPath 5000 V6.0, Provisional Service Manual
P31003-H3560-S403-54-7620, 09/05