Main Configurations; Dialing Mode On An External Analog Line; Default Access To A Group Of External Lines - Siemens HiPath 1100 Series Programming Manual

Step by Step
1

Main Configurations

Some settings may be modified right from the begin-
ning. In most cases, however, we recommend using
the default settings. If you need to change any settings,
see the following chapters:
Dialing Mode on an External Analog
Line
This features specifies the dialing mode to be used over
an external analog line (DP or MF).
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
1 9
Enter a number for an external analog line (e.g., 801).
... Enter the appropriate code:
2
= Analog line: Pulse dialing (DP)
1
= Analog line: Multifrequency tone dialing (MF)
2
Enter the next external line number.
or
Press this key.
#
Initial state for Programming Mode.
Default Access to a Group of External
Lines
This feature configures the access method to be used
for a group of external lines. The default external line
access code is "0."
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
0 0 2
Enter the extension number (e.g., 11/101).
(default
for all analog lines)
Main Configurations
17