Setting Up A Two-Cabinet System Side By Side; Figure 4-56 Hipath 3750 - Installing A Two-Cabinet System (Side By Side) - Siemens HiPath 5000 Service Manual

4.3.3.4.7

Setting Up a Two-Cabinet System Side by Side

Procedure
Step
1. Remove the front and rear
2. Place the system cabinets side by side at the installation site and make sure that
they are level and stable. Correct any differences in height.
3. If mounting the system on the floor or on a table, attach the two cabinets using
four connecting plates each held by two screws with washers (Figure 4-56).
Make sure that the connecting plates are mounted in the correct direction (inside
the cabinets and pointing inward).
DANGER
7
The connecting plates must be installed to ensure proper grounding for free-stand-
ing systems.
Installing a two-cabinet system
BC
Figure 4-56 HiPath 3750 - Installing a Two-Cabinet System (Side By Side)
Laying the Connecting Cables
To lay the connection cables between the cabinets, first remove the lower grills in the rear cov-
ers.
P31003-H3560-S403-54-7620, 09/05
HiPath 3000 V6.0, HiPath 5000 V6.0, Provisional Service Manual
cabinet
BC
EC1
Washers
Installing HiPath 3750, HiPath 3700
Activity
covers.
Inside the cabinet
inst_h3.fm
Installing HiPath 3000
EC1
4-103