boards.fm
Boards for HiPath 3000
Options
3.4.9
GEE12 (nor for U.S.), GEE16 (not for U.S.), GEE50 (not for U.S.)
Introduction
Each of the modules listed below supports four call-metering receiving units for recording and
preprocessing call charge pulses in HiPath 3550 and HiPath 3350.
Table 3-171
GEE12/GEE16/GEE50 (Not for U.S.) Modules
Module
Frequency
GEE 12
12 kHz
GEE 16
16 kHz
GEE 50
50 Hz
The call charge detection channel is looped in the trunk and then routed to the TLA
Interfaces
to the TLA
To CO
LS
Figure 3-157
GEE12, GEE16, GEE50 (Not for U.S.) - Interfaces (S30817-Q951-Axxx)
3-360
also for Silent Reversal
1
X3
10
1
GEE module
X4
8
HiPath 3000 V6.0, HiPath 5000 V6.0, Provisional Service Manual
Remarks
CB side
1
10
X5
Board side
P31003-H3560-S403-54-7620, 09/05
X1
X2