Caution
7
The following board assignment rules must be observed to ensure that the system
works properly and without blocking:
SLC16N
●
–
Maximum SLC16N per PCM segment. The SLC16N should be configured
alone on the PCM segment, where possible.
–
Note the following information on the subject of multi-SLCs: "SLC16N board
distribution in HiPath 3750 and HiPath 3700 cabinets" on page 3-156.
IVML8, IVML24 (see Section 3.3.6)
●
–
A maximum of one IVML8 or IVML24 per system.
–
Then install them in the slot beside the power supply in the basic cabinet or
the expansion cabinets.
–
No SLC16N may be inserted in the PCM segment of the IVML8/IVML24.
–
No SLMO24 may be inserted in the PCM segment of the IVML24.
–
If a TMS2 is configured on the PCM segment of the IVML24, only a board
with a maximum of 8 ports may be inserted in the free slot.
SLMO24
●
A maximum of two SLMO24s per PCM segment; the number of connected sta-
tions (hosts (master) and clients (slaves)) may not be more than 64.
The figures below show the PCM segments (64 time-division multiplex channels each) for the
different HiPath 3750 and HiPath 3700 system configurations.
Single-cabinet system: PCM segments
"8-slot" cabinets
C
0
0
0
0
B
2
3
4
5
C
P
R
BC
Figure 4-90
PCM Segments for a One-Cabinet System
P31003-H3560-S403-54-7620, 09/05
HiPath 3000 V6.0, HiPath 5000 V6.0, Provisional Service Manual
0
0
0
U
6
7
8
P
S
M
Installing HiPath 3000
Installing HiPath 3750, HiPath 3700
inst_h3.fm
4-159