Software Upgrade - Siemens HiPath 5000 Service Manual

9.3.2

Software Upgrade

If the software is a version earlier than V3.0, it must first be upgraded to V3.0. Only then is it
possible to upgrade the software to V6.0.
CDB conversion is also necessary.
Procedure: Customer database (CDB) conversion
Please note the following:
>
S stations can be configured as both HFA clients and vCAPI clients in V4.0. In ad-
0
dition, V4.0 does not have a selected gatekeeper board. This configuration will have
to be re-defined when upgrading to
The flowchart on Page 9-32 describes the procedure for converting the CDB from
V4.0 to
and finally, edit the
No other changes are necessary apart from modifications for IP workpoint clients
and IP lines. Only the gatekeeper and gateway data has to be edited. Telephone
numbers and other properties of the IP workpoint clients are retained. The protocol
has to be modified for the IP lines.
V4.0 configuration
HG 1500 board System clients
slot 4
S
HFA clients
S
vCAPI clients
HG 1500 board System clients
slot 6
S
HFA clients
Lines
Figure 9-15 Differences Between V4.0 and
P31003-H3560-S403-54-7620, 09/05
HiPath 3000 V6.0, HiPath 5000 V6.0, Provisional Service Manual
V5.0. First, you must edit the V4.0 CDB. Then you must convert the CDB
V5.0 CDB.
station:
0
station:
0
station:
0
Expanding and Upgrading HiPath 3000
Upgrading HiPath 3000 to V6.0
V5.0 (see Figure 9-15).
V5.0 configuration
System clients
H.323 clients
Lines
S station
0
V5.0 Configurations
exup.fm
HG 1500 board
slot 4
HG 1500 gate-
keeper
HG 1500 board
slot 6
HG 1500 gateway
9-31