Peripheral Boards; Csape - Siemens HiPath 5000 Service Manual

Hide thumbs Also See for HiPath 5000:

Table of Contents

Boards for HiPath 3000

Peripheral Boards

Peripheral Boards

The system must be powered down and de-energized before removing or inserting

all boards in the HiPath 3550, HiPath 3350, HiPath 3500, HiPath 3300 and before

removing or inserting the central boards of the HiPath 3800, HiPath 3750 and Hi-

The HiPath 3550, HiPath 3350, HiPath 3500 and HiPath 3300 peripheral boards must be firmly

inserted into their slots; otherwise contact problems can cause board failure.

Introduction

In V6.0 or later, the cPCI box CSAPE (Central Shelf Access Point Emergency) can be installed

in the HiPath 3800 basic cabinet. The cPCI box contains two fan drawers, the AC power supply

unit ACPCI (part number S30124-X5166-X), and two slide-in shelves for the Embedded Appli-

cation Server EAS.

CSAPE is required when using HiPath All-in-One applications. Information about the supported

applications can be found in the HiPath All-in-One product documentation.

Installation of the cPCI box CSAPE in the system is a purely mechanical operation. There is no

electrical connection between the system and the cPCI box CSAPE All communication be-

tween HiPath 3800 and HiPath All-in-One takes place over the IP network.

HiPath 3000 V6.0, HiPath 5000 V6.0, Provisional Service Manual

P31003-H3560-S403-54-7620, 09/05

Table of Contents

Hipath 3000 Hipath 3800