Siemens HiPath 5000 Service Manual page 1018

service.fm
Service
Guided Maintenance
Table 12-7 HiPath 3000 Class B Error Messages
No.
35 No ELIC interrupts
36 SDRAM: Access to protected area
37 SDRAM: Write error, wrong address
38 SDRAM: Read error, wrong address
Error Class B-30 - Firmware/Loadware
6 HDLC Controller Error on board
Error Class B-40 - MMC
0 MMC defective
Error Class B-41 - LAN
4 Send: Ethernet driver not ready
8 Send: More than 15 futile attempts
9 Send: Delayed collision detection
10 Send: Carrier loss
11 Receive: Frame error
12 Receive: FIFO error
13 Receive: Checksum error
14 Receive: Defective receiving buffer
15 Receive: Frame too short
16 Receive: Frame too long
17 Receive: Delayed collision detection
18 Receive: Partial deletion of data due to the
existing write protection
12-56
Meaning
HiPath 3000 V6.0, HiPath 5000 V6.0, Provisional Service Manual
Action
Recovery
Hard restart Notify appropriate service
Hard restart
Hard restart
–
Reload board
Hard restart
– For errors that appear
sporadically, no action is
–
–
For errors that appear reg-
ularly, replace the LIM
–
module. If this does not
–
correct the error, check
–
the LAN configuration.
–
–
–
–
–
–
P31003-H3560-S403-54-7620, 09/05
Action
Technician
support
Replace board
Replace MMC
necessary.