Connecting Peripherals To The Connector Panels With Sipac 1 Su; Connectors; Figure 4-36 Hipath 3800 - Connector Panel With Two Sipac 1 Su Connectors - Siemens HiPath 5000 Service Manual

Hide thumbs Also See for HiPath 5000:

Table of Contents

Installing HiPath 3000

Installing HiPath 3800

Connecting Peripherals to the Connector Panels with SIPAC 1 SU

The boards should be installed in the cabinets as described in Section 4.2.5. The S30807-

Q6631-X connector panels attached to the SIVAPAC connectors on the backplane have two

SIPAC 1 SU connectors each.

HiPath 3800 - Connector Panel with Two SIPAC 1 SU Connectors (S30807-

Be sure to connect the main protective earthing terminal on all system cabinets to

the grounding point of the electrical building installation before connecting up the pe-

ripherals (for example, potential equalization bus).

The system may only be started (connected to the power supply) if all system cabi-

nets are sealed at the rear with the connection and filler panels provided.

Use the CABLUs that are listed in the following table to establish the connection with the

MDFU-E or an external patch panel. See also Section 4.2.7, "Using an External Main Distribu-

tion Frame or External Patch Panel".

In special cases where the prefabricated CABLUs cannot be used, open-end cables should be

Cables and connectors for ports 17 - 24

Cables and connectors for ports 1 - 16

HiPath 3000 V6.0, HiPath 5000 V6.0, Provisional Service Manual

P31003-H3560-S403-54-7620, 09/05

Table of Contents

Hipath 3000 Hipath 3800