Lim - Siemens HiPath 5000 Service Manual

3.2.12

LIM

Caution
7
The LAN interface module must not be plugged in or out when the system is ener-
gized.
Place the central control board on a flat surface before inserting the LIM subboard.
The spacing bolts supplied guarantee the correct insertion of the subboard, so you
should always mount them (see Figure 3-6).
Otherwise you may damage the board.
Introduction
The LAN Interface Module (LIM - S30807-Q6930-X) is an optional plug-in card for all HiPath
3000 central control boards apart from
The board provides an Ethernet (10BaseT/10 Mbps) LAN connection via an 8-pin RJ45 jack.
The LIM module can be used for administration via HiPath 3000 Manager E and for CTI func-
tions (TAPI 120 V2.0). However, bear in mind that the number of BHCAs (Busy Hour Call At-
tempts = number of connection attempts during busy traffic hours) is restricted to 400 at a max-
imum of six TAPI ports. The use of "power dialers" is not approved.
You cannot operate the LIM module and a HG 1500 board simultaneously in a HiPath 3000.
RJ45 jack assignment
Table 3-23 LIM - RJ45 Jack Assignment
Pin
1
2
3
4
5
6
7
8
P31003-H3560-S403-54-7620, 09/05
HiPath 3000 V6.0, HiPath 5000 V6.0, Provisional Service Manual
Signal
Tx + Transmit +
Tx – Transmit –
Rx + Receive +
– Not used
– Not used
Rx – Receive –
– Not used
– Not used
CBSAP (HiPath 3800).
Description
boards.fm
Boards for HiPath 3000
Central Boards
3-51