Optipoint Blf; Figure 10-8 Optipoint Blf - Siemens HiPath 5000 Service Manual

wclient.fm
Workpoint Clients
optiPoint 500
Double assignment can be performed for the keys if only call numbers without LED support are
saved on the first level. It is also possible to program call numbers without LED support on the
second level. These can be internal station numbers, DID call numbers and call numbers from
a HiPath network (see also Page 10-5).
10.2.2.2

optiPoint BLF

This is an add-on device that provides 90 additional keys, LEDs and labeling areas for all pur-
poses.
The device is connected to the telephone or to an optiPoint key module over an interface cable
with the following connectors: input MW6, output MW8.
Power is supplied using a power supply unit (see Section 10.7.1.1) that can supply power to up
to two optiPoint BLFs. The power supply unit must be plugged directly into the designated op-
tiPoint BLF port.
Figure 10-8 optiPoint BLF
P31003-H3560-S403-54-7620, 09/05
10-18
HiPath 3000 V6.0, HiPath 5000 V6.0, Provisional Service Manual